The engine code P0010 indicates a problem with the car’s variable valve timing, probably caused either by engine oil sludge or by a failure of the engine control module. Engine codes can give you direct insight into your engine’s health — but sometimes those codes take some work to translate.
How serious is a P0010 code?
A P0010 code is moderately severe. Whilst it will not prevent your vehicle from running, you will experience a decrease in power, an increase in fuel consumption and ultimately, your car will fail a future emissions test.
Is P0010 intake or exhaust?
Code P0010 is triggered when the ECM attempts to adjust the Bank 1 intake camshaft timing by utilizing one of these valves, and it detects an electrical issue in either the circuit going to the valve or the windings of the solenoid in the valve itself.
Where is camshaft position sensor a bank 1 located?
A camshaft position sensor (CMP) is essentially a component in the format of a cylinder, which is often located on the outside of the front cover (at the front of the engine under the valve cover).
Where is the camshaft actuator located?
The exhaust camshaft actuator features a black electrical plug and is located closer to the rear of the vehicle on the top of the cylinder head.
How do I know if my fans are exhaust or intake?
How do I know if my fans are intake or Outake?
If the fan blades look rounded—that is, they’re curving away from you—that’s the intake side. (For the more technical out there: The convex side of the fan blades is the intake side.) Fan blades curving toward you? That’s the exhaust side.
Is there a difference between intake and exhaust VVT solenoid?
The exhaust valve is still controlled by way of an oil pressure solenoid, while the intake is controlled by an electric motor on the front of the cam. This allows valve timing to be adjusted with no regard to engine temperature or oil pressure.
Is P0011 intake or exhaust?
The camshaft(s) is(are) adjusted by the engine computer through the use of an oil control valve(s) (OCV), also called variable valve timing control solenoid valves. When trouble code P0011 is set, it means that the intake camshaft in Bank 1 is more advanced than the engine computer has told it to be.
Resetting the fault codes and performing a road test.
Changing the oil and filter to the proper oil viscosity for the engine specifications.
Repairing or replacing the wiring to the camshaft oil control valve for bank 1 intake camshaft.
Can a bad camshaft sensor cause P0011 code?
If your check engine light is on and you’re getting a Code P0011, it means that your camshaft position sensor needs to be replaced.
Will changing the oil fix P0011?
It is very possible that the P0011 code came up due to low engine oil, making the VVT system ineffective. If this is the case, all you have to do is check the oil level and fill it up to an appropriate level. If it turns out that the problem is with the oil level, it is a simple and easy fix.
Can dirty oil cause a P0011 code?
One of the most common causes of engine code P0011 is having low or dirty oil in your engine.
Can spark plugs cause P0011 code?
Bad or faulty spark plugs can cause a P0011 code in your car, especially if there is a fault or damage to the crankshaft position sensor and the ECM not firing the spark plugs.
How is P0011 code diagnosed?
How Do I Fix Trouble Code P0011?
Visually Inspect the System. Start with a visual inspection of the connector, wiring, and valve.
Check Your Oil. Check the condition of the engine oil.
Rescan the Codes. Scan your codes again and capture the freeze frame data.
How to reset the camshaft position sensor? Evidently, you cannot reset a camshaft position sensor. Therefore, you will need to replace the component if your camshaft malfunctions (check engine light on, acceleration issues, sputtering and stalling, etc.).