It is on the left hand side of the engine compartment under a protective cover. You will have to remove this cover to gain access to the fuses.
How do you know if a fuse is blown?
Remove the fuse from its holder. In some cases you may need a small screwdriver to unscrew the fuse holder cap. Look at the fuse wire. If there is a visible gap in the wire or a dark or metallic smear inside the glass then the fuse is blown and needs to be replaced.
How do I know if my f150 fuse is blown? – Related Questions
Where are the main fuses located?
Look for the fuse box in closets, hallways, mudrooms, crawl spaces, basements, utility rooms, or laundry rooms. Fuse boxes in more prominent locations might be covered with a wood panel or picture meant to disguise the appearance of the box cover or door.
Where is the sync fuse on 2009 F150?
Where is the fuel pump fuse located at on a 2010 Ford F-150?
The fuel pump relay location on a 2010 Ford F-150 is in the power distribution box in the engine compartment in position 27.
How do I reset my 2010 f150?
Where is the fuel pump shut off switch on a 2010 Ford F-150?
The fuel pump shut-off switch is located behind an access panel in the right rear quarter trim panel, near the liftgate. The fuel pump shut-off switch has a red reset button on top of it.
What fuse is for that trailer lights on a 2010 f150?
There is one fuse location and two relay locations you will want to check in the power distribution box in the engine compartment. First, check the 20-amp fuse in location 45. This is the Trailer tow stop turn relay feed.
What fuses control the trailer lights?
If you’re problem was turn signals then simply look for the trailer RT or LT fuse and simply replace if needed. This will solve the problem of brake lights also, as they are the same fuse.
Checking and replacing bulbs may be all that is required, but if not, you’ll need to look at the wiring. Many trailer problems are due to a poor grounding connection, which is usually the white wire coming out of the trailer plug. If the ground is poor, lights may work intermittently or not at all.
Where is the trailer lights fuse located?
How do I reset the power on my trailer?
Why do my brake lights work but not my running lights?
Failing Sensor
If a sensor fails, it can interrupt this complex design and cause a part to stop functioning properly. If both the headlights and parking lights fail along with the tail lights but the brake lights keep working, a sensor is likely to blame.
Is there a separate fuse for each tail light?
It depends on the vehicle type. Older models have tail lights and brake lights on the same fuse. However, newer models could have these lights on separate fuse. On many vehicles both lights operate using the same bulb known as a dual-filament bulb but with different circuits.
Can a blown fuse make your tail lights not work?
Electrical Issues
If you have a malfunctioning tail light, it could be a matter of a blown fuse. The fuses work with your car’s electrical panel and if they’re blown, it can cause several lights to stop working. Replace the fuse and see if this helps. Another issue may be related to your wiring.
A blown fuse. If the bulb or socket isn’t the problem, the next check is the fuse or the light switch. Fuses for everything electrical, including your tail lights, are always found in the fuse box. They are usually located under the hood or in the cabin.
How do I know if my tail light fuse is blown?
A blown fuse usually causes both lights to go out. On newer cars, the tail lamps can be fused separately and/or each bulb or shared circuit can be fused. A fuse can be blown due to other problems, so you’ll need to check more than just the fuse, but it’s the right place to start.