Table of Contents
ToggleHow do you reset the oil life on a 2015 Ford Explorer?
How do you reset the oil life on a 2014 Ford Explorer?
How do you reset the oil light on a 2017 Ford Explorer?
How do you reset the oil life on a 2013 Ford Explorer? – Related Questions
How do I reset the oil change required light?
- Switch the ignition on.
- Fully press the accelerator and brake pedals at the same time.
- Keep the accelerator and brake pedals fully pressed.
- After three seconds, a message displays confirming the reset procedure is in progress.
How do you reset the oil change light?
How do you reset the service light on a 2017 Ford Ranger?
How much oil does a 2017 Ford Explorer take?
Capacity: With filter 6 quarts. After refill check oil level.
How do you reset the oil light on a Ford Explorer 2021?
How do you reset the oil light on a Ford Explorer 2020?
How do you reset the oil change light on a 2000 Ford Explorer?
How do you reset the oil life on a 2022 Ford Explorer?
How do you reset the oil change light on a 2010 Ford Explorer?
How do you reset the oil life on a 2008 Ford Explorer Sport Trac?
- Turn the ignition to run (one position before starting engine).
- Press SETUP to display OIL LIFE %.
- Press RESET button to display “HOLD RESET IF NEW OIL”.
- Press and hold the RESET button for more than two seconds.
How do you reset the oil life on a 2009 Ford Expedition?
How do you reset the oil light on a 2007 Ford Explorer Sport Trac?
How do you reset the oil light on a 2007 Ford?
What does the wrench symbol mean on a 2006 Ford Explorer?
The wrench warning light on Ford vehicles is the powertrain malfunction indicator light. When it illuminates, it means that the computer has detected an issue with your vehicle’s powertrain or four-wheel-drive system.
How do you reset the tire sensor on a 2006 Ford Explorer?
Locate the TPMS reset button (usually beneath or near the steering wheel), and hold it until the light on the dashboard blinks three times. Release the button, start the ignition, and the light should be off. Add air to all tires (including the spare tire) to 3 PSI over the recommended amount.
How do you reset the tire pressure sensor on a 2007 Ford Explorer?
1) Turn the ignition switch to the OFF position, then press and release the brake pedal. 2) Turn the ignition switch from the OFF position to the RUN position three times, ending in the RUN position. Do not wait more than one minute between each key cycle. 3) Press and release the brake pedal.