The Best in Auto Repair
The average cost for a Chevrolet Traverse suspension shock or strut replacement is between $370 and $472. Labor costs are estimated between $147 and $185 while parts are priced between $224 and $287.
What are the symptoms of a failing strut?
The Warning Signs Of Worn Shocks And Struts
- Instability at highway speeds.
- Vehicle “tips” to one side in turns.
- The front end dives more than expected during hard braking.
- Rear-end squat during acceleration.
- Tires bouncing excessively.
- Unusual tire wear.
- Leaking fluid on the exterior of shocks or struts.
Is it OK to only replace front struts?
Do you have to replace both shock absorbers or struts if only one is bad? It’s not necessary, but it’s usually recommended to replace them in pairs, for example, both front struts or both rear shocks. This is because a new shock absorber will absorb road bumps better than the old one.
What are the most common problems of a 2011 Chevy Traverse?
The 2011 Chevy Traverse’s 3.6L V6 is known for timing chain issues, faulty piston rods, bearing failures, and excessive oil consumption. HVAC issues and power steering failure are not uncommon, as are malfunctioning window controls and water ingress. The 2011 Chevrolet Traverse is not a very reassuring prospect.
How much is it to replace front struts on a 2011 Chevy Traverse? – Related Questions
Why is my traverse so bouncy?
If the rack bushings become either too loose or too stiff (such as if they get stuck), your car will sway or bounce. Other damage to the steering linkage can cause this problem as well, though the rack bushings are the most common culprit.
How many miles will a 2011 Chevy Traverse last?
The average mileage you can expect from a Chevy Traverse is 200,000 miles.
What year traverse has transmission problems?
In all seriousness, transmission problems are some of the most common mechanical woes in a vehicle – including the Traverse SUV. We’ve seen plenty of reports from 2009 Traverse owners experiencing transmission issues around 80k+ miles.
How much does it cost to replace a timing chain on a 2011 Traverse?
The average cost for a Chevrolet Traverse timing chain and gear set replacement is between $2,080 and $2,418. Labor costs are estimated between $1,296 and $1,635 while parts are priced at $783.
What recalls does a 2011 Chevy Traverse have?
General Motors, LLC (GM) is recalling certain 2010-2015, 2017 Buick Enclave, 2010-2019 Chevrolet Traverse, and 2011-2016 GMC Acadia vehicles. The side curtain air bags may not be properly attached. Unsecured side curtain air bags may not perform as intended, increasing the risk of injury.
How much does it cost to change a timing belt on a 2011 Chevy Traverse?
Shopping around to get a few quotes is your best bet to get the best deal, but you can expect to pay anywhere from $409 to $919 (including parts and labor).
Is there any warning before timing belt breaks?
You need to look out for signs and symptoms of a weakening timing belt so that you can take action before it is too late. These include loud clicking sounds coming from your engine, squealing sounds, and your engine failing to start at all.
How long does it take to change a timing chain in a 2011 Chevy Traverse?
During the combustion process inside the cylinders, camshafts open and close the intake and exhaust valves at just the right time. Overall, it should take a qualified mechanic between 5 and 8 hours to replace the timing chain and all of the parts that go with it.
What are the signs of a timing belt going out?
Symptoms of a Bad or Failing Timing Belt
- You Hear A Ticking Noise Coming From The Engine.
- Your Car’s Engine Won’t Turn Over.
- You Notice An Oil Leak Near The Motor.
- You Experience Exhaust Issues.
- Your Revs Start Acting Up.
Should I replace my water pump with the timing belt?
Generally, the idler pulleys, tensioner and water pump should always be replaced when the timing belt is replaced. In most cases, the timing belt drives the water pump, so it is the right time to replace the water pump. It is also recommended by the manufacturer. WORD TO THE WISE.
At what mileage does a timing belt break?
It is safer to replace the timing belt even earlier than the manufacturer recommends. In general, however, timing belts needs to be replaced from 60,000 miles up to 150,000 miles.
What noise does a timing belt make?
Generally, a timing belt that goes bad makes a noticeable ticking or clicking timing belt sound that is unusual. When the timing belt starts falling the ticking or clicking sound becomes pretty audible.