Fortunately, tail light bulb replacement isn’t difficult and shouldn’t take you more than 45 minutes to an hour to complete. Be aware that newer models may be a little more complicated than older ones, as there will be more wires to disconnect.
The Tail Light Assembly is the group of lights that are mounted on the rear-end of your vehicle. They consist of the tail-lights, brake-lights and the reversing lights. Each pair of lights serves a specific purpose for conspicuity during the night.
How much does it cost to replace a tail light assembly?
The Average Cost for Tail Light Cover Replacement Is $50 to $300 Depending on If You Go to the Mechanic or DIY. This price range is based on national averages for all vehicles and does not factor in taxes, fees, or your particular make and model.
Is it easy to replace a tail light assembly? – Related Questions
Why does a tail light have 3 wires?
A lot of trailer lights have 3 wires. One wire for running lights, one wire for turn signal and brake lights, and one wire for ground. Check the back of the light assemblies because it might indicate the functions of the wires.
Does AutoZone replace taillights?
While AutoZone doesn’t offer actual brake light replacement services, our team can assist you with any questions about the process, help you find the right products to get started, and maybe even give you a hand.
Can you replace tail light yourself?
Replacing a tail light bulb is usually a straightforward task on most cars, and should take a matter of minutes. However, on some models tail light bulb replacement requires panels to be removed either in the bootlid or the boot itself, depending on where the bulbs are installed.
What tools do you need to install rear tail lights?
You’ll likely need either a flathead or Phillips screwdriver. Grab whatever tools you need and remove the screws holding the taillight housing in place. If your vehicle provides easy access to the taillight housing, you might not need tools. Just snap off the fabric covering to expose the bulb in its socket.
The passenger side is normally green and carries the right turn and brake light. The driver’s side is normally yellow and carries the left turn signal and brake. The remaining functions are running/tail lights on the brown wire and the ground which is the white wire.
How do you install a tail light cover?
Grip behind the bulb much like you would if you were changing any light bulb.
Turn counter-clockwise and pull the bulb holder from the lens case.
Reverse the procedure, reinserting the light bulb holder into the new turn-signal cover and screw it back into place on the vehicle.
Can you drive with a missing tail light cover?
If you have a cracked or broken tail light cover, you may be asking, “Is it illegal to drive with a broken tail light cover?” The answer is typically yes.
What to do if tail light cover is broken?
If you simply have a crack in your tail light cover, some craft glue may do the trick. But, if the damage is more severe, you’ll want to cover the exposed area with some lens repair tape. You can get this at most auto parts stores – including here at the dealership.
How to remove tail light lens F 150?
How to replace a tail light cover on a Ford f150?
How do you remove lenses from tail lights?
How do you remove a tail light assembly?
Open the trunk of your vehicle and locate the back of the tail light assembly. Disconnect the wiring harness from the back of the tail light assembly. Remove the tail light assembly mounting screws or nuts. Push the tail light assembly out from behind.
Why do my brake lights work but my tail lights don t?
Failing Sensor
If a sensor fails, it can interrupt this complex design and cause a part to stop functioning properly. If both the headlights and parking lights fail along with the tail lights but the brake lights keep working, a sensor is likely to blame.
Why is my tail light not working after replacing bulb?
If the bulb or socket isn’t the problem, the next check is the fuse or the light switch. Fuses for everything electrical, including your tail lights, are always found in the fuse box. They are usually located under the hood or in the cabin. Fortunately, you can fix this type of problem by replacing the fuse.