The 2011 Chevy Traverse’s 3.6L V6 is known for timing chain issues, faulty piston rods, bearing failures, and excessive oil consumption. HVAC issues and power steering failure are not uncommon, as are malfunctioning window controls and water ingress. The 2011 Chevrolet Traverse is not a very reassuring prospect.
Does Chevy Traverse have engine problems?
The Chevrolet Traverse has had a lot of engine issues since 2009. Newer models have been upgraded, and Chevrolet seems to have reduced its Chevy Traverse engine faults to the absolute minimum. Many people also reported their engine shutting down, which was typically seen after a particular mileage.
How much horsepower does a 3.6 Traverse have?
Horsepower of the Chevy Traverse
The 2021 Chevrolet Traverse has 310 horsepower, the full ability of the standard 3.6L V6. This power is available in each model the 2021 Traverse provides, with the 3.6-liter engine being the only option.
How many miles will a 2011 Chevy Traverse last?
You can expect a Chevrolet Traverse to last 200,000 miles. If you drive 15,000 miles per year like the average American driver, that translates to 13.5 years of problem-free performance before you need to carry out major repairs on the vehicle.
What are the most common problems of a 2011 Chevy Traverse? – Related Questions
What are the worst years for the Chevy Traverse?
- Chevrolet Traverse SUVs from 2009 to 2012 are some of the model’s worst.
- Electrical issues plague the 2014 model with a malfunctioning electronic module that could short-circuit and cause the car to stop, as well as a faulty fuel gauge.
- Traverse SUVs from 2020 don’t have many complaints but have seven recalls.
Does a 2011 Chevy Traverse have a timing belt or chain?
Newer models use timing belts made of polyurethane and Kevlar for long life and durability. They can go as long as 100,000 miles although it’s always a good idea to change it before then. Belt failure can cause extensive damage to the valves, pistons and other internal parts of the engine.
What is considered high mileage on a 2011 vehicle?
What is considered high mileage on a car? Often, 100,000 miles is considered a cut-off point for used cars because older vehicles often start requiring more expensive and frequent maintenance when mileage exceeds 100,000.
How many miles should a 2011 used car have?
To determine whether a car has reasonable mileage, you can simply multiply 12,000 by its age. That means good mileage for a car that’s 5 years old is 60,000. Significantly more or fewer miles could indicate a problem or trouble in the future.
What is good mileage for a 2011 used car?
Mileage will vary between vehicles, but a decent rule of thumb to follow is that people drive an average of about 12,000 miles a year. Therefore, 120,000 miles would be a good mileage for a used car that’s about 10 years old.
How long does an engine last in a Chevy Traverse?
Standard 3.6L V6 Engine in Chevrolet Traverse is Known to Consistently Reach 200,000 Miles, but Routine Maintenance is a Must. Maintaining the engine and transmission is critical to the longevity of any vehicle, as powertrain repairs tend to carry the highest shop bills.
Is the 3.6 Chevy engine reliable?
Despite its rather lengthy list of problems, the GM 3.6 V6 is known to be quite bulletproof. The v6 power plant is powerful and tech-laden. Its Achilles heel though has to do with its engine oil changes.
Which Traverse is better LS or LT?
As we mentioned, the LT trim option is a step above the LS, so you’ll see some additional features and available add-ons. Below, you can find a list of all the special features of the Traverse LT that aren’t standard on the Traverse LS. Technology features include (in addition to LS features):
What recalls does a 2011 Chevy Traverse have?
General Motors, LLC (GM) is recalling certain 2010-2015, 2017 Buick Enclave, 2010-2019 Chevrolet Traverse, and 2011-2016 GMC Acadia vehicles. The side curtain air bags may not be properly attached. Unsecured side curtain air bags may not perform as intended, increasing the risk of injury.
How much is a timing chain for a 2011 Chevy Traverse?
The average cost for a Chevrolet Traverse timing chain and gear set replacement is between $2,080 and $2,418. Labor costs are estimated between $1,296 and $1,635 while parts are priced at $783.
Why is the Chevy Traverse so hard to find?
The extremely low supply of the Chevy Traverse is the result of the GM Lansing Delta Township plant that produces the Traverse being idled on July 19th, 2021 due to the ongoing global semiconductor microchip shortage that is expected to remain well into 2022.
How much does it cost to replace a transmission in a 2011 Chevy Traverse?
A 2011 Chevy Traverse transmission replacement cost can land at as much or over $3,500. It’s typically $2,500 to $3,500 just for the new transmission and you’ll need to factor in labor costs as well.
What are signs that the transmission needs to be replaced?
What Are the Transmission Failure Symptoms?
- Refusal to Switch Gears. If your vehicle refuses or struggles to change gears, you are more than likely facing a problem with your transmission system.
- Burning Smell.
- Noises When in Neutral.
- Slipping Gears.
- Dragging Clutch.
- Leaking Fluid.
- Check Engine Light.
- Grinding or Shaking.
Is it cheaper to rebuild a transmission or buy a new one?
When repairing a transmission you are basically replacing the minimum amount of parts so that the transmission is brought back to good working condition. This typically costs less, so it is smart to get the right diagnosis of your transmission the first time around.
What year Chevy Traverse had transmission problems?
After the first Chevy Transverse was released in 2009, later alterations were done and by 2018, some of the problems experienced in 2009 were fixed. Transmission failure is one of those problems. The 2009 Traverse owners had complained their SUVs limped down the road and they experienced the issue at 88,000 miles.
Why is my Traverse so bouncy?
If the rack bushings become either too loose or too stiff (such as if they get stuck), your car will sway or bounce. Other damage to the steering linkage can cause this problem as well, though the rack bushings are the most common culprit.