What causes a heater fan to stop working?

If the fan does not start, you have a wiring issue (circuit breaker trips) or motor problem (circuit breaker does not trip). While your thermostat may be at fault, only an HVAC technician can diagnose and remedy the issue correctly. Time to call in the experts!

Where is the blower fuse in a Nissan Rogue?

What causes a heater fan to stop working? – Related Questions

Where is the blower reset button?

It is usually located inside the blower compartment on the side of the blower motor. Be cautious as the housing may be hot. If the button is popped up, press it down.

How do I reset my blower motor?

How to Find and Reset your Furnace Motor Blower
  1. Step 1: Turn off the power to the furnace.
  2. Step 2: Remove the blower compartment cover.
  3. Step 3: Make sure the blower is completely cooled off.
  4. Step 4: Locate the reset button.
  5. Step 5: Press the button in (assuming that this is your issue and that the button has popped).

Where is the fuse for the fan blower?

Fuse Protection

To protect the blower motor power circuit, a 20-, 25- or 30-amp fuse is usually located in the fuse panel under the dash.

Where is the fuse for the front blower motor?

How can you tell if a blower fuse is blown?

If the blower motor isn’t running you should:
  1. Use voltmeter or ohmmeter to check for a blown fuse. If you find one, replace it.
  2. Start car and see if blower motor works.
  3. If the circuits are in good repair but the blower motor keeps blowing fuses, replace the blower motor [source: You Fix Cars].

How much does it cost to replace a blower motor relay?

Parts cost on average $36.73 – $44.89, and services cost $106.20 – $129.80. This repair takes on average 0.90h – 1.10h for a mechanic to complete. The blower motor pushes air out of the vents and into your car.

How do you test a blower relay?

How do you test a blower relay on a car?

Connect a test light or multimeter to the ground (black lead). Turn the ignition key to the on position (engine off), and remove the relay. Using the probe, test all terminal sockets in the relay connector. Two of the four should have power.

How do you know if a fan relay is stuck?

How Do You Know If Your Relay Is Stuck And Needs To Be Fixed?
  1. The air conditioner doesn’t turn on when you try to use it.
  2. The air conditioner turns off unexpectedly.
  3. You hear a clicking noise coming from the air conditioner.
  4. Visible damage or debris on the relay.

How do I know if I need to replace the blower motor or the resistor?

Here are some common signs that your vehicle’s blower motor resistor is bad: Loss of HVAC fan control (total or certain speeds) The fan only works on its highest speed setting. No air coming from vents.

Leave a Comment