What does service tire monitor system mean on a Chevy Traverse?

A Chevy “service tire monitor system” warning can mean one of two things. The first is that your tire pressure is suboptimal and requires adjusting to manufacturer-recommended levels. The second meaning applies if the warning does not go away after filling the tires or if a flashing TPMS light accompanies it.

What does the service tire monitor system mean?

The purpose of the TPMS (Tire Pressure Monitoring System) is to alert you when tire pressure is too low and could create unsafe driving conditions. If the light is illuminated, it means your tires could be underinflated, which can lead to undue tire wear and possible tire failure.

RELATED READING  Which tire is best for Nissan Altima?

How do you reset the tire pressure monitoring system on a Chevy Traverse?

When your vehicle is not running, turn the key to the “On” position, but don’t start the engine. Hold the TPMS reset button, and the tire pressure light should blink three times. Then, release the button and start your car. The TPMS sensor should refresh within 20 minutes.

How do you fix a service tire monitor system?

How do you fix the service tire monitor system?
  1. Turning the ignition to the on position without starting the engine.
  2. Locating the TPMS button and holding it down until the alert flashes or disappears.
  3. Driving around for a few minutes, turning off the car, and then restarting the engine.

What does service tire monitor system mean on a Chevy Traverse? – Related Questions

How much does it cost to fix a tire monitor system?

TPMS Replacement Costs and What to Expect

In the event TPMS sensors need to be replaced, the cost can range from approximately $50-$100 each depending on vehicle type.

How much does it cost to service tire monitor system?

The Best in Auto Repair

The average cost for TPMS sensor replacement is between $210 and $254. Labor costs are estimated between $55 and $69 while parts are priced between $155 and $185. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location.

Where is the tire monitor reset button?

The tire pressure monitor reset button is typically located under the steering wheel. Refer to your vehicle’s owner’s manual if you’re unable to locate it. Inflate all tires to 3 PSI over their recommended amount, then deflate them completely. Be sure to include the spare tire, as it may have a sensor as well.

RELATED READING  Who are Milestar tires made by?

Is there a fuse for tire pressure monitoring system?

The tire pressure warning system fuse is located in the fuse box located under the dash, just to the left of the steering column.

Where is the tire monitoring system located?

Where is the tire pressure sensor located? It is inside the tire attached to the inner part of the rim. If you remove the tire from the rim, you’ll see a small cylinder, which is the tire pressure sensor.

How do I know if my tire pressure sensor is broken?

After starting a vehicle, a TPMS icon will turn on for a few seconds; however, if it stays on, it indicates that one or more of the tires on the vehicle are at least 25% below the recommended pressure. If the light flashes for approximately one to two minutes, it indicates there is a malfunction in the TPMS system.

Can you drive with a faulty TPMS sensor?

The vehicle is still safe to drive as long as the tires are holding normal air pressure, but with the TPMS system offline there will be no low tire pressure warning if a tire starts to go flat. Generally, TPMS sensors should be replaced when needs it first set of tires, or after 5 to 7 years or 60,000 to 80,000 miles.

Why is my tire light on but tires are full?

Resetting Your Tire Pressure Light

If your TPMS light remains on after inflating the tires to the proper pressure, try these steps: Drive the car at 50 mph for about 10 minutes. This should reset the tire sensors, and the next time you start the car the TPMS light should be off.

RELATED READING  What brand tires does GMC use?

How much does it cost to fix a tire pressure sensor?

On average, you will have to spend between $30 to $75 for a sensor and around $10 to $35 in labor costs. Thus, the average cost of replacing a tire sensor can cost between $40 and $100.

Can I replace TPMS sensor myself?

If one of your TPMS sensors fails and needs replacement, you can replace it individually. However, if the failure was caused by a dead sensor battery, it’s likely that the other sensors are close to failing as well.

Will a tire pressure sensor reset itself?

Once your tires are at the appropriate pressure, the light may go off on its own. If it doesn’t go off right away, driving at 50 mph for about 10 minutes should help the tire pressure sensor reset.

What happens if you don’t replace TPMS sensors?

For any motorists that swap their tires out for changing seasons, it’s crucial that the TPMS sensors are reactivated and recalibrated each time. If this is not done, the vehicle’s TPMS will not perform properly and may cause the TPMS light to turn on.

Is it worth it to replace TPMS sensors?

A: Tire pressure monitoring sensor batteries are designed to last 10 years. It sounds as though yours may have died. The law does not demand that you replace the sensors, but for your peace of mind, convenience and safety’s sake, it makes sense to replace them.

How many years do TPMS sensors last?

TPMS sensors run on batteries that can last anywhere from 5-10 years. Sensor battery life will depend on how much driving you do over time and the conditions that you drive in.

Leave a Comment