What does SVC tire monitor mean on a 2008 Chevy Malibu?
by
When your tire is low, the tire monitor system will kick in. A light will come on in the message center on your dashboard or an actual message will flash across the screen, telling you that you have a low tire.
How do you reset the SVC tire monitor on a 2008 Chevy Malibu?
Turn your vehicle’s key to the “On” position without starting the vehicle.Push the TPMS reset button until the tire pressure light flashes three times, then let go. Start the car and wait for about 20 minutes for the tire pressure sensor to refresh.
What does it mean when my Chevy Malibu says service tire monitor system?
A Chevy “service tire monitor system” warning can mean one of two things. The first is that your tire pressure is suboptimal and requires adjusting to manufacturer-recommended levels. The second meaning applies if the warning does not go away after filling the tires or if a flashing TPMS light accompanies it.
Can you drive with the light on for your tire monitoring system? If you carefully check your tires, you can drive with your TPMS light. Since these systems often break down for reasons that have nothing to do with air pressure, you can still drive the car even though this light is on.
What does SVC tire monitor mean on a 2008 Chevy Malibu? – Related Questions
How do I fix my service tire monitor?
Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and let it run for 20 minutes, which allows the sensors to reset. You’ll find the tire pressure monitor reset button located beneath the steering wheel.
How much does it cost to fix a tire monitor system?
TPMS Replacement Costs and What to Expect
In the event TPMS sensors need to be replaced, the cost can range from approximately $50-$100 each depending on vehicle type.
Can you drive without tire pressure sensors?
Basically there is no problem in running tires without the tire pressure sensors other than, as you point out, the warning light showing at all times. These devices came out of the fiasco a few years back when Ford and Firestone were initially blamed for a number of incidents blamed on either the vehicle or tires.
How long can I drive with TPMS on?
As discussed, on paved roads under ideal conditions, you should not drive farther than 50 miles or longer than one hour when your tires have low pressure.
The light indicates that the pressure is below the safe levels. Ignoring the warning and driving with low-pressure tires causes them to flex more. It generates excess heat that overheats the tire components and causes them to wear and tear.
Can I drive with low tire pressure signal?
Is it Safe to Drive? If your tire pressure is only slightly low, you should be able to drive safely for a few more miles until you can add air. Tire pressure that is extremely low can lead to tire failure. This can result in a blowout, which can be extremely dangerous.
Why is my tire pressure light on when my tires are fine?
If the light keeps on for long periods of time, it’s most likely due to a small issue (a tire pressure sensor reset is required) or that you’ll have to bring it into the shop for repairs (one or more sensors may need replacing).
What tire pressure is dangerously low?
If you have standard passenger tires (ninety percent of vehicles do) the lowest tire pressure you can generally drive with is 20 pounds per square inch (PSI). Anything under 20 PSI is considered a flat tire, and puts you at risk for a potentially devastating blowout.
How do I get rid of low tire pressure signal?
Resetting Your Tire Pressure Light: Step-by-Step Guide
Drive at or above 50 mph to reset the sensor for 10 minutes.
With the vehicle off, turn the key to the “ON” position, but do not start your vehicle.
Inflate all tires to 3 PSI over their recommended amount, then deflate them completely.
How much does it cost to fix a tire pressure sensor?
On average, you will have to spend between $30 to $75 for a sensor and around $10 to $35 in labor costs. Thus, the average cost of replacing a tire sensor can cost between $40 and $100.
Once your tires are at the appropriate pressure, the light may go off on its own. If it doesn’t go off right away, driving at 50 mph for about 10 minutes should help the tire pressure sensor reset.
Is there a reset button for tire pressure sensor?
Where is the TPMS battery located?
How do I reset my TPMS without tool?
Programming TPMS without the tool
Make sure your tires are inflated to the recommended psi.
Turn ignition to the on position.
Push the hazard light button 6 times.
Release air pressure in the front left tire until you hear the horn honk.