Your car’s AC stopped working because of a failing compressor or a freon leak. Though these may be the obvious reasons for your AC not cooling inside your vehicle, it could also be anything as simple as a bad compressor belt or a dirty cabin air filter.
How much does it cost to fix AC in Kia Sportage?
On average, the cost for a Kia Sportage Car AC Repair is $245 with $112 for parts and $133 for labor. Prices may vary depending on your location.
What causes car AC to suddenly stop working?
So what caused your air conditioner to stop working? Most likely, your AC system lost its charge of refrigerant. Or, due to an electrical fault, its compressor is not engaging when you turn on the system. Another possibility is that an internal obstruction is blocking the circulation of refrigerant.
Why is my AC kicking on but not cooling?
If your air conditioner will turn on, and your thermostat is set properly, but your system is not cooling you may have a dirty or blocked air condenser. Your first step is to check the outside unit and clean around and remove any debris or weeds that are blocking air circulation.
Why is my AC not working in my Kia? – Related Questions
What do you do if your car AC is running but not cooling?
The most common causes of broken air conditioning are leaks or compressor issues. If your air is blowing cool but not cold, the problem could be a clogged filter, cooling fan problem, radiator trouble, or it could simply be that you need to recharge your AC.
Why would AC suddenly stop cooling?
Perhaps the most common cause of AC issues is clogged filters. Dirt, pet hair, pollen and dust can clog your filters. When filters get clogged, they begin to restrict the flow of air through your AC. The result is that the AC doesn’t cool your indoor air effectively.
Can a blown fuse cause AC not to work?
Electrical Issues
While this prevents serious trouble such as electrical fires, it also means that a single blown fuse can cause the entire air conditioner to stop working. Some of the most common causes of AC failure are rooted in electronics.
How do I reset my air conditioner?
How do you reset your AC unit?
- Turn off your air conditioning system using the thermostat.
- Search for the breaker box.
- Shut off your AC unit at the breaker.
- Wait at least a full minute before switching the breaker back to the “on” position.
- Wait for 30 minutes before turning your unit back on at the thermostat.
Where is my AC reset button?
Look for it first around on the exterior of your machine, especially along the bottom edge near the ground. An AC’s reset button is typically red and visible, so it should be easy to spot. If you don’t see a reset button on the outside, it could be located inside the unit behind the service panel.
How do I know if my AC fuse is blown?
If there is the voltage on the “line” side, test for voltage on the “load” side of the fuses by placing the meter’s leads on the load wire lugs. If you read voltage on this side(220-240V), this means the current is flowing through the fuse. If you get a zero-voltage reading on the load, this means your fuse is blown.
Is there an AC reset button?
Most air conditioning units are equipped with a reset button. These buttons tend to be red and quite small. If you’re having a tough time finding it, consult your owner’s manual.
How long does it take for an AC unit to reset?
After you’ve turned the system back on, it will take a bit of time for the air conditioner’s internal circuitry to reset. It usually takes about 30 minutes, so sit tight until then.
How do I get my AC to work again?
If your air conditioning system just isn’t turning on then we suggest you run through a few things before calling in an HVAC expert:
- Make sure the outdoor breaker fuse is positioned correctly.
- Check your electrical panel for a tripped breaker.
- Confirm that your thermostat is switched on.
- Check for a clogged air filter.
How do I get my AC to run again?
That said, follow these steps to unfreeze your AC unit quickly:
- Turn the thermostat from COOL to OFF.
- Turn the fan setting to ON.
- Check your filter and replace it if needed.
- If the filter isn’t dirty, call a professional before turning the AC back on.
How do I get my air conditioner to work again?
If your AC is not cooling but runs:
- Turn off the power.
- Clean or change the air filter to improve airflow.
- Look to see if ice has formed on the coils and, if it has, turn on the power and the fan to melt it.
- Clean the condensate drain.
- Finally, check and clean the outdoor compressor.