If your remote starter system isn’t working properly, try replacing the battery in your fob. You can find replacement key fob batteries at Batteries Plus. Most remote starter fobs run on 2032 lithium coin cell batteries. This one may seem obvious, but if your vehicle is not in “Park” your remote starter will not work.
How do you reset the remote start on a Chevy Equinox?
On your Chevy key fob, press and hold the “Unlock” and “Lock” buttons simultaneously until you hear the door locks engage and disengage again, indicating that you have successfully programmed your key fob. Re-insert the newly programmed key into the ignition in the “On” position to end the programming sequence.
Why won’t my remote start work on my Chevy Equinox?
What is this? If your remote start is not working, you should check if you did it right and make sure your engine temperature is not high. You should also turn off the hazard lights, properly close the hood and gas cap, and make sure the car is in ‘park mode.
How do I reset my remote control starter?
Press the Lock button on your remote car starter. Within five seconds of turning it on, turn your key back to the “off” position (or press the start button again). Repeat the on-off cycle three more times—you’ll do four in total.
Why is my Chevy remote start not working? – Related Questions
How do I reprogram my remote start autostart?
What causes remote start to disable?
There are several reasons your remote start may be disabled, including: Defective hood switches or sensors. Problem with batteries. Vehicle not in park mode.
Why is my remote not working even with new batteries?
The remote control battery terminals may be dirty. Remove the batteries and clean the remote control terminals with a small solution of alcohol, using a cotton bud or soft cloth, then place the batteries back into the remote control. Replace with fresh batteries.
Does check engine light affect remote start?
If the ‘Check Engine Light’ or Malfunction Indicator Lamp (MIL) is illuminated, the remote start will not work. Don’t panic, one of the reasons the MIL can illuminate is due to a loose gas cap!
the battery inside the remote is dead. the remote itself is broken or no longer programmed to your car. the car battery is low. the keyless operation system is faulty.
How do I enable my remote start?
Can a remote start on a car drain a battery?
If a new remote-start mechanism was installed by someone other than the manufacturer, you run the risk of having it installed improperly. This mistake can lead to other problems, such as a premature draining of your vehicle’s battery.
Can key fob battery stop car from starting?
Q: Can a low battery key fob cause car not to start? Yes, a low battery key fob can cause your car not to start.
Does remote start drain key fob battery?
In as much as starting the car will drain your battery, yes. If you mean while not being used, your car has systems that are always “alive” even when you turn off the ignition.
What kills key fob battery?
One thing you should never do is leave your key fob in your car overnight. Whenever the fob is in range of your vehicle, it connects with your car’s sensor system. Not only can this drain the battery in your remote, it can potentially kill your car battery too.
What is the average life of a key fob battery?
Typically, a car fob battery should last between three and four years. Additionally, there are a number of signs that will tell you when your fob battery is dying.
How long do remote car starters last?
A car starter can last somewhere between 200,000 and 30,000 miles.