Why is my remote start not working on my Chevy Silverado?
by
Some reasons why remote start might not work is if the function is disabled if the hood is not closed, if the key fob is inside the car (to prevent you from locking yourself out), or if the hazard lights are on. Check these if you’re having any trouble.
How do you reset the remote start on a Chevy Silverado?
On your Chevy key fob, press and hold the “Unlock” and “Lock” buttons simultaneously until you hear the door locks engage and disengage again, indicating that you have successfully programmed your key fob. Re-insert the newly programmed key into the ignition in the “On” position to end the programming sequence.
If your remote starter system isn’t working properly, try replacing the battery in your fob. You can find replacement key fob batteries at Batteries Plus. Most remote starter fobs run on 2032 lithium coin cell batteries. This one may seem obvious, but if your vehicle is not in “Park” your remote starter will not work.
How do I reset my remote control starter?
Press the Lock button on your remote car starter. Within five seconds of turning it on, turn your key back to the “off” position (or press the start button again). Repeat the on-off cycle three more times—you’ll do four in total.
Why is my remote start not working on my Chevy Silverado? – Related Questions
How do I reprogram my remote start autostart?
What causes remote start to disable?
Your remote start may not function because the batteries in the key fob are dying. You may also have installed the battery improperly or used the wrong batteries.
How do I reset my remote after replacing my battery?
How do you resync a remote control?
Turn on your TV or another device you wish to control. Press and hold the corresponding DEVICE and POWER buttons on the remote at the same time. Wait until the power button comes on, and then release both buttons. Pointing the remote at the TV or another device, press the Power button on the remote and wait 2 seconds.
How much does it cost to reprogram a remote starter?
While it’s hard to give a universal estimate, the general cost is between $50 and $250 for reprogramming. Here’s a look at some factors that can determine price: Fob Type: Smart keys with a transponder (RFID), keyless ignition, or other extra features tend to be more expensive to reprogram.
AutoZone provides a variety of key fobs that work for most vehicle makes, and they will help you match and program your fob to your car. Key fobs can range from $20 to $400 depending on the vehicle and the type of fob you buy.
Will check engine light cause remote start not to work?
If the ‘Check Engine Light’ or Malfunction Indicator Lamp (MIL) is illuminated, the remote start will not work. Don’t panic, one of the reasons the MIL can illuminate is due to a loose gas cap!
Do I have to reprogram my key fob if I change the battery?
Typically, you do not need to reprogram the key fob after changing the battery. However, if you’ve replaced not just the batteries but also some of the internal wiring and electronics, you may need to reprogram it by pairing it with your vehicle once again.
Why is my remote not working even with new batteries?
The remote control battery terminals may be dirty. Remove the batteries and clean the remote control terminals with a small solution of alcohol, using a cotton bud or soft cloth, then place the batteries back into the remote control. Replace with fresh batteries.
Why won t my key fob work after replacing battery?
For your remote key fob to work properly, it has to be connected to a receiver in the vehicle. When the battery in the fob is replaced, it can sometimes interfere with the paired connection between key and car, in which case you’ll need to reset it.
For most car key fobs, the battery life is three to four years with normal use, Freeman says.
Why does my key fob battery drain so fast?
“A key fob will constantly try to communicate with the car. And that does cause a slight drain on the battery, but generally that won’t completely drain a healthy car battery,” says Mike Monticello, Consumer Reports’ road test manager.
How do I know if my key fob is bad?
Most modern fobs can send a signal to your vehicle from up to 50 feet away. As your battery wears out though, both the range and signal strength will be reduced. If you find yourself having to repeatedly push buttons to lock and unlock doors, that’s another sign that your key fob battery needs to be replaced.
What happens if my key fob battery dies while driving?
If your key fob dies while driving, nothing will happen. The car will continue to operate simply because the key fob is an unlocking and starting device only. Once the car is in motion, the ability of the key fob to affect the ignition or engine is zero.
What kills key fob battery?
LEAVING YOUR KEY CLOSE TO YOUR CAR
Leaving your car key in your car overnight or even on a hook near the car is not recommended. If the fob is too close to your car, it can continue to communicate with it, which could drain the battery.
How long before key fob battery dies?
Most car fob batteries will last for three to four years with regular use. But if you regularly leave your key near your car, it’s likely the battery will drain faster. To help your fob battery last longer, you should store your key at least 10 feet away from your car.