Diagnostic trouble code (DTC) P043e stands for “Evaporative Emission System Leak Detection Reference Orifice Low Flow.” The EVAP system uses a vapor canister to trap excessive fuel vapors until the engine is in a suitable condition to burn them.
How To Correct P043E Evaporative Emission System Leak Detection Reference Orifice Low Flow
Replace the defective EVAP pressure sensor.
If there are some faults in the vent control or purge control solenoid, then it should be repaired or replaced.
The vacuum pump module should be replaced.
What can cause a small EVAP leak code?
Here are Some Possible Causes for an EVAP Code or an EVAP Leak:
Missing or loose fuel cap.
Incorrect fuel cap used.
Evaporative (evap) emission canister or fuel tank leaks.
Evaporative (evap) emission system hose leaking.
Fuel tank leaking.
A small leak in any of the EVAP hoses or fuel tank hoses.
How do you fix an EVAP emission control system leak?
If you see a P0442 evaporative emission system leak detected code, you may be able to resolve the problem without much effort. The easiest solution may be to remove and reaffix the gas cap. Once you do, clear the code on the OBD-II diagnostic scanner and drive for a few days.
Yes, you are still safe to drive. The EVAP (Evaporated Emission Control System) is used to prevent gasoline vapors from escaping into the air from the fuel tank system to control greenhouse emissions.
Can I fix an EVAP leak myself?
Depending on where the leak is in the system and whether or not there is another damage, you can expect to pay up to $600 or so to fix a leak in your vehicle’s EVAP system. If you have an OBD2 code reader at home, you can diagnose the problem yourself, but it’s best to leave the fixing to the professionals.
What happens if you don’t fix EVAP leak?
The main issue with not repairing the EVAP system is that of passing an emissions test as required in most states. Anytime this system is not working properly, your car will not pass an emissions test.
What happens if you don’t fix the EVAP?
When you don’t fix an EVAP problem, the check engine light will stay on, masking other problems that might occur. Of course, if local regulations require passing an emissions test, your vehicle will fail. Finally, harmful emissions are being released into the atmosphere.
How much does it cost to fix an evaporative emission control system?
It works to get rid of harmful gasoline vapors before they have a chance to make you or your passengers sick. Evaporative emissions canisters typically cost anywhere from $200 to $700 or more to replace.
When the EVAP system is not functioning correctly, fuel vapors can escape from the fuel tank and enter the engine. This issue can cause the engine to run rich and damage the catalytic converter.
Are EVAP leaks a big deal?
While it is safe to drive with an EVAP system leak, it causes excess car pollution. Fixing the problem is often as simple as tightening the gas cap.
What is the most common EVAP leak?
Some of the more common EVAP system leak codes are:
P0456 — Evaporative Emission System Leak Detected (Very Small Leak)
P0442 — Evaporative Emission Control System Leak Detected (Small Leak)
P0455 — System Gross Leak Evaporative Emission (Large Leak)
P0457 — Evaporative Emission System Leak Detected (Loose Fuel Cap)
Does EVAP leak affect gas mileage?
Decreased Gas Mileage
When a canister purge valve doesn’t open as it should, your gas mileage might be negatively affected. The vapors in your car used in combustion will go to the EVAP canister then get vented out into the environment, causing you to use some of the fuel that your car would usually use for burning.
How long does it take to repair an EVAP leak?
It can take anywhere from a few minutes to several hours. Replacing your gas cap is the easiest and cheapest fix for around $20, while locating an EVAP leak in either the vacuum feed lines or charcoal canister may be more difficult and run you upwards of $600.
Does EVAP system affect acceleration?
On top of a rough idle, a vehicle with a failing EVAP canister purge valve will display signs of poor engine performance. The engine may feel like its running “weak” and won’t generate sufficient power for acceleration. Accelerating will feel like you’re pressing the pedal down and moving slower.
Q: How do you detect an EVAP leak? A: The best and easiest way to detect whether or not your vehicle has an EVAP leak is to perform the “smoke” test. All you have to do is blow smoke into the EVAP system and then see if any smoke leaks from a valve, seal, tool, or hose.
How do I know if my EVAP is clogged?
Does EVAP affect how vehicle runs?
If the check engine light comes on due to a problem or specific failure within that system, it’s very unlikely you’ll notice any difference in the actual operation of the vehicle. That’s because the EVAP system doesn’t affect your driving, it only effects your emissions.
Does EVAP affect AC?
The evaporator might just be the most important part of your car’s A/C system. Well, every part is important, but the evaporator is what determines the air temperature you feel inside the cabin — which is effectively what keeps you cool all year long.